How To Configure Tcp Mss; Configuring Tcp Mss (Cli); Configuring Tcp Mss (Gui) - Cisco IOS XE Release 3SE Configuration Manual

How to Configure TCP MSS

How to Configure TCP MSS

Configuring TCP MSS (CLI)

SUMMARY STEPS
1. configure terminal
2. ap tcp-adjust-mss size size_value
3. reload
4. show ap tcp-adjust-mss
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
ap tcp-adjust-mss size size_value
Example:
Switch(config)# ap tcp-adjust-mss
size 537
Step 3
reload
Example:
Switch# reload
Step 4
show ap tcp-adjust-mss
Example:
Switch# show ap tcp-adjust-mss

Configuring TCP MSS (GUI)

Step 1 Choose Configuration > Wireless > Access Points > Global AP Configuration.
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
86
Purpose
Enters global configuration mode.
Enables the TCP MSS on the particular access point that you specify.
To enable TCP MSS on all the access points that are associated
Note
with the switch, enter the ap tcp-adjust-mss size size_value
command, where the size parameter is from 536 to 1363 bytes.
The default value varies for different clients.
Reboots the switch in order for your change to take effect.
Displays the current TCP MSS setting for all the access points that are
associated with the switch.
To display the TCP MSS settings that correspond to a specific
Note
access point, enter the show ap name Cisco_AP tcp-adjust-mss
command.
Configuring Link Latency
OL-28697-01