Optimizing RFID Tracking
•
•
•
•
Finding Feature Information
Optimizing RFID Tracking on Access Points
To optimize the monitoring and location calculation of RFID tags, you can enable tracking optimization on
up to four channels within the 2.4-GHz band of an 802.11b/g access point radio. This feature allows you to
scan only the channels on which tags are usually programmed to operate (such as channels 1, 6, and 11).
How to Optimize RFID Tracking on Access Points
Optimizing RFID Tracking on Access Points (CLI)
SUMMARY STEPS
1. ap name Cisco_AP mode monitor submode none
2. ap name Cisco_AP dot11 24ghz shutdown
3. ap name Cisco_AP monitor-mode tracking-opt
4. ap name Cisco_AP monitor-mode dot11b {fast-channel [first_channel second_channel third_channel
fourth_channel]}
5. ap name Cisco_AP no dot11 24ghz shutdown
6. show ap monitor-mode summary
OL-28697-01
Finding Feature Information, page 71
Optimizing RFID Tracking on Access Points, page 71
How to Optimize RFID Tracking on Access Points, page 71
Configuration Examples for Optimizing RFID Tracking, page 72
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
11
C H A P T E R
71