Cisco IOS XE Release 3SE Configuration Manual page 96

Configuring Link Latency (CLI)
Command or Action
Step 4
ap tcp-adjust-mss size size
Example:
Switch(config)# ap tcp-adjust-mss
size 537
Step 5 show ap name Cisco_AP config
general
Example:
Switch(config)# show ap name AP02
config general
Step 6 ap name Cisco_AP link-latency [reset]
Example:
Switch(config)# ap name AP02
link-latency
reset
Step 7 show ap name Cisco_AP config
general
Example:
Switch(config)# show ap name AP02
config general
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
84
Purpose
To enable or disable link latency for specific access points that are
Note
associated with the switch, enter the following commands in Priveleged
EXEC mode:
• ap name Cisco_AP link-latency—Enables link latency.
• ap name Cisco_AP no link-latency—Disables link latency.
Configures TCP MSS adjust size for all access points. The range is from 536
to 1363.
Displays the general configuration details of the access point. These
configuration details contain the link latency results that correspond to the
access point that you specify in the command.
The output of this command contains the following link latency results:
• Current Delay—The current round-trip time (in milliseconds) of CAPWAP
heartbeat packets from the access point to the switch and back.
• Maximum Delay—Since the time that link latency has been enabled or
reset, the maximum round-trip time (in milliseconds) of CAPWAP
heartbeat packets from the access point to the switch and back.
• Minimum Delay—Since the time that link latency has been enabled or
reset, the minimum round-trip time (in milliseconds) of CAPWAP
heartbeat packets from the access point to the switch and back.
Clears the current, minimum, and maximum link latency statistics on the switch
for a specific access point.
Displays the general configuration details of the access point. Use this command
to see the result of the reset operation.
Configuring Link Latency
OL-28697-01