Converting Autonomous Access Points To Lightweight Mode; Finding Feature Information; Prerequisites For Converting Autonomous Access Points To Lightweight Mode - Cisco IOS XE Release 3SE Configuration Manual

Converting Autonomous Access Points to
Lightweight Mode
•
•
•
•
•
•
•
•
•
•
•

Finding Feature Information

Prerequisites for Converting Autonomous Access Points to
Lightweight Mode
• Access points that are converted to lightweight mode do not support Wireless Domain Services (WDS).
OL-28697-01
Finding Feature Information, page 53
Prerequisites for Converting Autonomous Access Points to Lightweight Mode, page 53
Information About Autonomous Access Points Converted to Lightweight Mode, page 54
How to Convert a Lightweight Access Point Back to an Autonomous Access Point, page 56
Authorizing Access Points (CLI), page 57
Authorizing Access Points (GUI), page 58
Disabling the Reset Button on Converted Access Points (CLI), page 59
Monitoring the AP Crash Log Information, page 60
How to Configure a Static IP Address on an Access Point, page 61
Recovering the Access Point Using the TFTP Recovery Procedure, page 63
Configuration Examples for Converting Autonomous Access Points to Lightweight Mode, page 63
Converted access points communicate only with Cisco wireless LAN switchs and cannot communicate
with WDS devices. However, the switch provides functionality that is equivalent to WDS when the
access point associates to it.
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
8
C H A P T E R
53