Table of Contents
Advertisement
Configuring Adaptive Wireless Intrusion Prevention System
Command or Action
Example:
Switch# ap name AP01 monitor-mode
wips-optimized
Step 6
show ap dot11 24ghz monitor
Example:
Switch# show ap dot11 24ghz monitor
Step 7
ap name Cisco_AP no dot11 5ghz shutdown
Example:
Switch# ap name AP01 no dot11
5ghz shutdown
Step 8
ap name Cisco_AP no dot11 24ghz shutdown
Example:
Switch# ap name AP01 no dot11
24ghz shutdown
Configuring wIPS on an Access Point (GUI)
Step 1
Choose Configuration > Wireless > Access Points > All APs
The All APs page is displayed.
Step 2
Click the access point name.
The AP > Edit page is displayed.
Step 3
From the AP Mode drop-down list, choose one of the following options to configure the AP mode parameters:
• Local
OL-28697-01
Purpose
The access point scans each channel for 250 milliseconds. It derives
the list of channels to be scanned from the monitor configuration.
You can choose the following options:
Displays the monitor configuration channel set.
Note
Enables the 802.11a radio on the access point.
Enables the 802.11b radio on the access point.
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
Configuring wIPS on an Access Point (GUI)
• All—All channels supported by the access point's radio.
• Country—Only the channels supported by the access point's
country of operation.
• DCA—Only the channel set used by the dynamic channel
assignment (DCA) algorithm, which by default includes all of
the nonoverlapping channels allowed in the access point's
country of operation.
The 802.11b Monitor Channels value in the output of the
command indicates the monitor configuration channel set.
39
Advertisement
Table of Contents
