Configuration Examples For Configuring Link Latency; Running A Link Test: Example; Displaying Link Latency Information: Example - Cisco IOS XE Release 3SE Configuration Manual

Configuration Examples for Configuring Link Latency

Command or Action
Step 5
end
Example:
Switch(config)# end
Configuration Examples for Configuring Link Latency

Running a Link Test: Example

This example shows how to run a link test:
Switch# test wireless linktest 00:0d:88:c5:8a:d1
When CCX v4 or later releases is enabled on both the controller and the client being tested,
information similar to the following appears:
CCX Link Test to 00:0d:88:c5:8a:d1.
Link Test Packets Sent...................................... 20
Link Test Packets Received.................................. 10
Link Test Packets Lost (Total/AP to Client/Client to AP).... 10/5/5
Link Test Packets round trip time (min/max/average)......... 5ms/20ms/15ms
RSSI at AP (min/max/average)................................ -60dBm/-50dBm/-55dBm
RSSI at Client (min/max/average)............................ -50dBm/-40dBm/-45dBm
SNR at AP (min/max/average)................................. 40dB/30dB/35dB
SNR at Client (min/max/average)............................. 40dB/30dB/35dB
Transmit Retries at AP (Total/Maximum)...................... 5/3
Transmit Retries at Client (Total/Maximum).................. 4/2
Transmit rate: 1M 2M 5.5M 6M 9M 11M 12M 18M 24M 36M 48M 54M 108M
Packet Count: 0 0 0 0 0 0 0 0 0 2 0 18 0
Transmit rate: 1M 2M 5.5M 6M 9M 11M 12M 18M 24M 36M 48M 54M 108M
Packet Count: 0 0 0 0 0 0 0 0 0 2 0 8 0
When CCX v4 or later releases is not enabled on either the controller or the client being
tested, fewer details appear:
Ping Link Test to 00:0d:88:c5:8a:d1.
Link Test Packets Sent.......................... 20
Link Test Packets Received...................... 20
Local Signal Strength........................... -49dBm
Local Signal to Noise Ratio..................... 39dB

Displaying Link Latency Information: Example

This example shows how to display general configuration details of the access point. These configuration
details contain the link latency results that correspond to the access point that you specify in the command.
Switch# show ap name AP01 config general
Cisco AP Name
Cisco AP Identifier
Country Code
Regulatory Domain Allowed by Country
AP Country Code
AP Regulatory Domain
Switch Port Number
MAC Address
Lightweight Access Point Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
88
Purpose
Returns to privileged EXEC mode. Alternatively,
you can also press Ctrl-Z to exit global configuration
mode.
: AP01
: 55
: US - United States
: 802.11bg:-A 802.11a:-A
: US - United States
: Unconfigured
: Te1/0/1
: 0000.2000.03f0
Configuring Link Latency
OL-28697-01