Kx-Tde, Kx-Tda, And Kx-Taw Series Pbx Programming For Inband Integration - Panasonic KX-TVA50 Installation Manual

5.3 KX-TDE, KX-TDA, and KX-TAW Series PBX
Programming for Inband Integration
DPT Integration is recommended when using the VPS with a KX-TDE, KX-TDA, or KX-TAW series PBX,
however, Inband Integration is necessary when the PBX has available SLT ports but no available DPT ports.
The screen shots shown in this section are for the KX-TDA200. Programming procedures and
availability may vary by PBX model, software version, etc. Refer to the documentation included with
the PBX or consult your dealer for more information.
1.
Assignment of VM (DTMF) Group
a.
Go to the Groups-VM(DTMF) Group-Group Setting screen.
b.
Assign a floating extension number to the desired VM (DTMF) Group.
c.
Select AA as the service type.
d.
Assign extension numbers to Extension Number of the SLT Port connected to VM. Incoming calls
will hunt starting at the lowest VM Port number.
e.
Click Apply to save the changed data.
2.
Program the appropriate trunk (CO line) feature settings depending on how your customer plans to use
the VPS.
•
The VPS answers all incoming trunk (CO line) calls promptly.
See Example Settings (1) later in this section.
•
The VPS answers when the operator does not take the call after a specified time.
See Example Settings (2) later in this section.
•
The VPS answers when an Incoming Call Distribution (ICD) group does not take the call after a
specified time.
See Example Settings (3) later in this section.
Document Version 3.0 2010/06

5.3 KX-TDE, KX-TDA, and KX-TAW Series PBX Programming for Inband Integration

Installation Manual 135