Error Codes - Olivetti OFX 800 User Manual

ERROR CODES

The error codes are printed on both the transmission and activity reports and are represented by two digits indicat-
ing the cause of the error. Due to limited space, only the code is indicated without any message on the activity re-
port.
CODE
01 / 09 No document present
02 Will not connect
03 Recipient does not answer
04 Error during transmission
05 Re-transmit pages:
07 Document too long
08 Check document
10 Reception errors
11 Will not receive
13 Polling error
14 Confidential TX/RX
15 Number not enabled
16 Power failure
21
pressed
22 Engaged
23 Will not receive
78
ERROR
Document to be transmitted missing.
Place the document in the ADF.
No connection to the remote party's fax machine.
Check that your remote party's fax machine is connected,
switched on and free and that the number called is correct.
His fax machine is disconnected, switched off or busy.
Check that your remote party's fax machine is connected,
switched on and free and that the number called is correct.
Interference on the line or some other fault.
Try re-transmitting, starting from the page number indicated on
the transmission report.
The pages indicated were not transmitted.
Reinsert the pages indicated into the ADF and re-transmit.
The document does not comply with the format stated or exceeds
the maximum dimensions permitted.
Set the document format correctly or repaginate it to lie within the
allowed dimensions.
Paper jam.
Remove the document or paper that has jammed and check that
documents in the ADF and paper in the ASF have been correctly
loaded.
Interference on the line.
Ask your remote party to re-transmit the document.
Memory full.
Cancel unwanted documents from the fax memory.
Document not correctly stored and/or connection problems and/or
interference on the line.
Make sure the document has been correctly stored and that the
machines are correctly connected, installed and set.
Invalid address / Transmission/reception operations are protected
by a password.
Check that the address is correct and/or that the remote party has
created a confidential mailbox.
Type the password to continue the operation.
Number called not enabled.
Check the number you have dialled, and confirm it with the re-
mote party to / from whom you wish to transmit / receive.
A power failure occurred during a TX/RX operation.
The operation in progress has been interrupted.
An engaged tone was received before or after the connection was
made.
Try re-transmitting.
Fax machine in condition in which it cannot receive (for example,
no paper in ASF and memory full).
CAUSE/SOLUTION
K
EEPING THE FAX MACHINE IN GOOD WORKING ORDER