Reception And Copying Problems - Sharp FO-2150 Operation Manual

Problems and Solutions

Reception and copying problems

Problem
The Sharp MFP doesn't
receive documents
automatically.
The power is on, but no
reception takes place.
The Sharp MFP appears
to answer calls, but
doesn't print out any
faxes.
The printing paper does
not come out.
The printing paper comes
out blank when you try to
receive a document.
The received document
is faint.
Received images are
distorted.
12-6
Check and remedy
Make sure that the reception mode is set to
FAX or TEL/FAX. If you do not subscribe to
a distinctive ring service, make sure that
Distinctive Ring is turned off. (See
Distinctive Ring in Chapter 8.)
Make sure that the wall jack is connected to
the TEL. LINE socket, and not the TEL.
SET socket.
Faxes will be received to memory if a color
cartridge is installed, media is loaded in the
manual sheet feeder, or a print cartridge or
paper jam problem has occurred. Check the
display for error messages. (If a document
is loaded in the document feeder, READY
TO SEND will appear. Remove the
document to allow any error messages to
appear.)
The printing paper may be jammed. See
Clearing jammed printing paper
chapter.
Make sure that the document is loaded
properly in the feeder of the transmitting
machine. Make a copy to confirm the
printing ability of your machine.
The print cartridge may need replacement.
Printing at low temperature may result in
faint output.
Noise on the telephone line may cause
distortion. Have the other party try sending
the document again.
Make a copy of another document on the
Sharp MFP. If the copy is also distorted,
your Sharp MFP may need service.
in this