Table of Contents
Advertisement
Chapter 5 WAN Setup
Table 14 WAN Configuration: PPPoE
LABEL
Authentication
Method
Enable Fullcone
NAT
Dial on Demand
Inactivity
Timeout
Use Static IPv4
Address
IPv4 Address
Enable PPP
Debug Mode
Bridge PPPoE
Frames Between
WAN and Local
Ports
Enable IGMP
Multicast Proxy
Back
Next
64
DESCRIPTION
The ZyXEL Device supports PAP (Password Authentication Protocol)
and CHAP (Challenge Handshake Authentication Protocol). CHAP is
more secure than PAP; however, PAP is readily available on more
platforms.
Use the drop-down list box to select an authentication protocol for
outgoing calls. Options are:
AUTO - Your ZyXEL Device accepts either CHAP or PAP when
requested by this remote node.
CHAP - Your ZyXEL Device accepts CHAP only.
PAP - Your ZyXEL Device accepts PAP only.
MSCHAP - Your ZyXEL Device accepts MSCHAP only. MS-CHAP is the
Microsoft version of the CHAP.
Select this option to enable full cone NAT on the ZyXEL Device.
Select this check box when you do not want the connection up all the
time and specify an idle time-out in the Inactivity Timeout field.
Specify an idle time-out when you select Dial on Demand. The
default setting is 0, which means the Internet session will not timeout.
A static IPv4 address is a fixed IP that your ISP gives you. A dynamic
IP address is not fixed; the ISP assigns you a different one each time
you connect to the Internet. Select this if you do not have a dynamic
IP address.
Enter the static IP address provided by your ISP.
Select this option to display PPP debugging messages on the console.
Select this option to forward PPPoE packets from the WAN port to the
LAN ports and from the LAN ports to the WAN port.
In addition to the ZyXEL Device's built-in PPPoE client, you can select
this to allow up to ten hosts on the LAN to use PPPoE client software
on their computers to connect to the ISP via the ZyXEL Device. Each
host can have a separate account and a public WAN IP address.
This is an alternative to NAT for application where NAT is not
appropriate.
Clear this if you do not need to allow hosts on the LAN to use PPPoE
client software on their computers to connect to the ISP.
Select this check box to have the ZyXEL Device act as an IGMP proxy
on this connection. This allows the ZyXEL Device to get subscribing
information and maintain a joined member list for each multicast
group. It can reduce multicast traffic significantly.
Click this button to return to the previous screen.
Click this button to continue.
P-870H/HW Series User's Guide
Advertisement
Table of Contents
