Configuration (Standalone); Sound-Active Mode; Automatic Mode; Static Mode - Chauvet SlimPAR User Manual

Configuration
(Standalone)
Sound-Active
Mode

Automatic Mode

Static Mode

Custom Static
Colors
Master/Slave
Mode
SlimPAR™ 64 User Manual Rev. 5
Set this product in one of the standalone modes to control it without a DMX controller.
·
Connect this product to a suitable power outlet.
Never connect a fixture that is operating in any standalone mode, whether Static,
Automatic, or Sound to a DMX string connected to a DMX controller. This is
because fixtures in standalone mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
To enable the Sound-Active mode, do the following:
1) Press <MENU> repeatedly until P-- shows on the display.
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select P5 or P6.
4) Press <ENTER>.
5) Turn the music on and adjust the microphone sensitivity knob until the fixture starts
reacting to the beat of the music.
The fixture will only respond to the low frequencies of the music (bass and
drums).
To enable the Automatic Mode, follow the instructions below:
1) Press <MENU> repeatedly until P-- shows on the display.
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select P1~P4.
4) Press <ENTER>.
5) Press <MENU> repeatedly until S-- shows on the display.
6) Use <UP> or <DOWN> to adjust the speed at which the program plays (S001~100).
7) Press <ENTER>.
To enable the Static mode, do the following:
1) Press <MENU> repeatedly until C-- shows on the display.
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select the preset color (C1~C7).
4) Press <ENTER>.
To enable the Custom Static Colors mode, do the following:
1) Press <MENU> repeatedly until U-- shows on the display.
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select the desired color: red (r--), green (g--), or blue (b--).
4) Press <ENTER>.
5) Use <UP> or <DOWN> to select the desired color value (000~100).
NOTE: Selecting 000 will turn the color off.
6) Press <ENTER> to continue to the next color.
7) Repeat steps 5 to 7 until you create your desired color.
8) Press <ENTER> to save the color.
This mode allows a single SlimPAR™ 64 unit (the "master") to control the actions of one
or more SlimPAR™ 64 units (the "slaves") without the need of a DMX controller. The
master unit will be set to operate in either Automatic or Sound-Active mode, while the
slave units will be set to operate in Slave Mode. Once set and connected, the slave units
will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1) Press <MENU> repeatedly until 3-CH or 7-CH shows on the display.
2) Press <ENTER> to accept.
3) Use <UP> or <DOWN> to set the starting address to d001.
4) Press <ENTER>.
5) Connect the DMX input of the first slave unit to the DMX output of the master unit.
6) Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
7) Finish setting and connecting all the slave units.
Master unit:
1) Set the master unit to operate in either Automatic or Sound mode, as previously
indicated.
2) Make the master unit the first unit in the DMX daisy chain.
Page 9 of 12