Table of Contents
Advertisement
Configuration
(Standalone)
Static Programs
Automatic
Programs
Auto-Program
Speed
Sound-Active
Mode
Sound
Sensitivity
Auto and Sound
Modes
Beamer 8 User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the Beamer 8 in static mode, follow the instructions below:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a static program (C 1–3).
4.
Press <ENTER>.
To run the Beamer 8 in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select an auto program (P 1–9).
4.
Press <ENTER>.
To change the auto-program speed on the Beamer 8, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the program speed (S. 1– 99).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the Beamer 8 in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Use <UP> and <DOWN> to select a sound program (Snd1–9).
3.
Press <ENTER>.
To change the sound sensitivity on the Beamer 8, turn the sound sensitivity adjustment
knob up until the product responds to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
Program
1
2
3
4
5
6
7
8
9
Effect
All – Beams and Strobes
All – Beams and Strobes
All – Beams and Strobes
Beams Only
Beams Only
Beams Only
Strobes Only
Strobes Only
Strobes Only
Page 11 of 17
Advertisement
Table of Contents
