Setup; Ac Power; Fuse Replacement; Power Linking - Chauvet SlimPAR User Manual

3. S
ETUP

AC Power

Fuse
Replacement

Power Linking

Power Linking
Diagram
Page 6 of 12
This product has an auto-ranging power supply and it can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture's specifications chart. A fixture's listed
current rating indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
This fixture uses an F 1 A, 250 V fuse. Follow the instructions below to change it in case
it blows.
Disconnect this product from the power outlet before replacing the fuse.
1) Wedge the tip of a flat-head screwdriver into the slot of the fuse holder and pry it out
of its housing.
2) Remove the blown fuse from its holder and replace it with a fuse of the exact same
type and rating.
3) Insert the fuse holder back in its place, and reconnect power.
Spare fusel
(inside safety cap)
This product ships with a spare fuse inside the safety cap, as shown above.
This fixture provides power linking via the Edison outlet located in the front of the unit.
Please see the diagram below for further explanation.
You can power link up to 40 SlimPAR™ 64 units on 120 VAC or up to 60
SlimPAR™ 64 units on 230 VAC.
The power linking diagram shown above corresponds to the North American
version of this product ONLY! If using this product in other markets, you must
consult with the local CHAUVET® distributor as power linking connectors and
requirements may differ in your country or region.
st nd
1 Fixture 2 Fixture
Installed fuse
(held by plastic clip)
Safety cap
rd
3 Fixture
Other fixtures
SlimPAR™ 64 User Manual Rev. 5