Configuration (Standalone); Auto Run Mode; Auto Programs - Chauvet COLORrail IRC IP User Manual

Configuration
(Standalone)

Auto Run Mode

Auto Programs

COLORrail™ IRC IP User Manual Rev. 6
Set the product in one of the standalone modes to control it without a DMX controller.
·
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
There is no <ENTER> button. After the COLORrail™ IRC IP is configured the
display will show the last item configured.
To enable the Auto Run mode, follow the instructions below:
1. Press <MENU> with long presses repeatedly until AUR shows on the display.
2. Press <MENU> with a short press. The display shows nXX.
3. Use <UP> or <DOWN> to select the number of runs through the auto run loop.
4. Press <MENU> with a short press. The display shows S.XX.
5. Use <UP> or <DOWN> to select the speed of the auto run loop.
6. Press <MENU> with a short press. The display shows F.XX.
7. Use <UP> or <DOWN> to select the strobe speed of the auto run loop.
To enable the Auto Program mode, follow the instructions below:
1. Press <MENU> with long presses repeatedly until P.XX shows on the display.
2. Use <UP> or <DOWN> to select an auto programs.
3. Press <MENU>.with a short press. The display will show the sub-menus options for
that Auto Program. See
4. Press <MENU> with a short press repeatedly until the display shows the sub-menu
options to be configured.
5. Use <UP> or <DOWN> to select the options within the sub-menu.
Menu Map.
Page 9 of 18