Performing A Raid Array Rebuild - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

I
Administrator permission required: If you are prompted for an
administrator password or confirmation, type the password or
provide confirmation.
Ê To enable a temporarily disabled BitLocker, click Turn On BitLocker.
Ê Follow the instructions in the BitLocker Setup wizard.
I
For further information on how to enable BitLocker drive encryption,
please refer to the Microsoft Knowledge Base.
Fujitsu service partners will find additional information (also available in
Japanese) on the Fujitsu Extranet web pages.

5.2.14 Performing a RAID array rebuild

After replacing a hard disk drive that has been combined into a RAID array,
RAID rebuild will be performed completely unattended as a background
process.
Ê Confirm that the RAID array rebuild has started normally and then complete
the replacement procedure. (Check the progress bar that the status has
proceeded at least 1%.)
Ê Inform the customer of the approximated remaining time for rebuild to
complete based on the displayed "Estimated time remaining" information.
Figure 24: Progress bar (RAID array rebuild)
V
CAUTION!
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the hard
disk drive capacity the overall process can take up to several hours, in
some cases even days.
I
You may notice a slight performance impact during rebuild.
TX140 S2
Upgrade and Maintenance Manual
Basic software procedures
91