Hard disk drives / solid state drives
7.2.4.3
Installing a 2.5-inch HDD / SSD dummy module
V
CAUTION!
If the removed HDD / SSD module is not replaced immediately, always
replace a dummy module into the unused HDD / SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 48: Installing a 2.5-inch HDD / SSD dummy module
Ê Slide the HDD dummy module into the drive bay until it locks in place.
7.2.4.4
Concluding steps
Ê If applicable,
"Installing the HDD bay cover" on page 64
128
Upgrade and Maintenance Manual
TX140 S2