Ê Secure the rack front cover to the chassis with two screws on either side
(see figure
8 on page
Ê Insert and slide the ID card into its slot until it locks in place (see close-up in
figure
6 on page
4.5.1.2
Installing the top cover
Figure 15: Installing the top cover (rack server)
Ê Check if the locking lever on the top cover is open.
Ê Lower the top cover onto the chassis, recessed by 2 cm (1).
Ê Close the locking lever on the top cover (2). This will slide the top cover shut
engaging the locking mechanism (3).
TX140 S2
53).
52).
Upgrade and Maintenance Manual
Basic hardware procedures
59