Tools You Need At Hand - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Before you start
Step
Assembly,
rack installation
Starting up
Table 1: Calculation of the average task duration
2.3

Tools you need at hand

When preparing the maintenance task, ensure that all required tools are
available according to the overview below. You will find a list of required tools at
the beginning of each procedure.
Screw driver /
Bit insert
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Phillips
PH2 / (+) No. 2
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Table 2: List of required tools and used screws
26
included Explanation
Reassembling the server, installing the
yes
server in the rack (if applicable)
Booting time depends on hardware and
no software configuration and may vary
significantly.
Screw
Upgrade and Maintenance Manual
Usage Type
M3 x 4.5 mm
Backup drives,
(silver)
optical disk
drives, chassis
C26192-Y10-C67
M3 x 5 mm
(silver)
USB 3.0
interface card
(contained in card
D3305
kit S26361-D3305-
A10)
M3 x 6 mm
(silver)
System board
C26192-Y10-C68
UNC
Backup drives
6-32 x 4.76 mm
with UNC
(black)
thread
C26192-Y10-C75
TX140 S2