Replacing The Riser Card; Preliminary Steps; Removing The Defective Riser Card - Fujitsu PRIMERGY TX140 S2 Upgrade And Maintenance Manual

Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable, "After replacing / upgrading LAN controllers" on page 94
9.4.4

Replacing the riser card

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
9.4.4.1

Preliminary steps

"Locating the defective server" on page 43
Ê
"Disabling BitLocker functionality" on page 69
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
Ê Remove all external cables from the expansion card installed in the riser
card slot.
"Getting access to the component" on page 47
Ê
"Removing the fan module" on page 151
Ê
9.4.4.2

Removing the defective riser card

Ê Remove the expansion card from the riser card slot as described in section
"Removing an expansion card" on page
TX140 S2
183.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Note on network
Hardware: 5 minutes
181.
185