Ê Enter BIOS recovery mode using the onboard jumpers.
I
For detailed information on jumper settings, refer to section
settings" on page
Ê Close the side / top cover as described in section
page
58.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section
server to the mains" on page
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V
CAUTION!
Do not interrupt the BIOS recovery process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side / top cover as described in section
component" on page
Ê Disable BIOS recovery mode using the onboard jumpers:
I
For detailed information on jumper settings, refer to section
settings" on page
Ê Close the side / top cover as described in section
page
58.
5.2.1.2
Updating or recovering the iRMC
iRMC flash procedure
I
For the Japanese market, follow the instructions provided separately.
Ê Prepare a USB stick including the bootable iRMC firmware update image.
Ê Connect the USB stick to the USB port.
TX140 S2
329.
67.
47.
329.
Upgrade and Maintenance Manual
Basic software procedures
"Reassembling" on
"Connecting the
"Getting access to the
"Reassembling" on
"Onboard
"Onboard
77