Configuring The Www Screen; The Telnet Screen - ZyXEL Communications P-660H-61 User Manual

18.2.1 Configuring the WWW Screen

Click Advanced > Remote MGMT to display the WWW screen.
Figure 110 Advanced > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 81 Advanced > Remote Management > WWW
LABEL
Server Port
Server Access
Secured Client IP
Address
Apply
Cancel

18.3 The Telnet Screen

You can use Telnet to access the ZyXEL Device's command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
ADSL Router Series User's Guide
DESCRIPTION
This displays the service port number for accessing the ZyXEL Device. If the number is
grayed out, it is not editable.
Select the interface(s) through which a computer may access the ZyXEL Device using
this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > System > General). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See
page 60 for information on configuring firewall rules.
A secured client is a "trusted" computer that is allowed to communicate with the ZyXEL
Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 18 Remote Management
Section 4.8 on
221