Mode Switch - Sharp XE-A107 Instruction Manual

. ■ Mode.Switch
Insert the mode key (the same key as drawer lock key) into the mode switch and move the key to
get an appropriate mode.
Mode key
. ■ Display
Your cash register is equipped with a front LED (Light-Emitting Diode) display that affords easy
visibility of 9 digits for the operator during transaction.
Department code
Repeat
PLU code
Symbols.and.figures.appearing.on.the.display:
Error:
Program:
Finalization:.. Appears when a transaction is finalized by pressing
Subtotal:
Change:
Exchange:
Low.battery:
No.battery:
• When the department key sign is set to "minus", a minus sign (-) appears.
NOTE
• The decimal point is shown as " ".
• When secret code is set, "----" appears when characters are entered.
To.display.the.time.and.date
Set the mode switch to the REG position, and press
twice to display the date.
Press key to cancel the time/date display.
l
4 4
Appears when an error is made. If this occurs during a transaction because of
an extra digit entry, simply press
Appears when the cash register is being programmed in the "Z/PGM" mode.
Appears when the cash register computes a subtotal when
also when an amount tendered is less than the total sales amount.
Appears whenever a change due amount is displayed.
Appears when is pressed to calculate a subtotal in foreign currency.
V
Appears when the voltage of the installed batteries is under the required level.
You need to replace the batteries with new ones very soon.
Appears when the batteries are not installed, or the installed batteries are dead.
You must immediately replace the batteries with new ones.
: Turns the display off. No operations are
possible.
REG: Permits transaction entry.
: Permits correction after finalizing a
transaction.
X/Flash: Permits printing of sales reports and
displaying the flash reports.
Z/PGM: Permits printing and resetting of sales
reports and programming.
Department.code: Indicates the department entered.
. PLU.code: Indicates the PLU code entered.
. Repeat: Indicates the number of times the
and re-enter correctly.
l
once to display the time or press
Q
For example, if department 1 was
pressed, "1" would appear.
same department key or PLU key is
pressed repeatedly. If an entry is
repeated more than ten times, only
the last digit is displayed.
, or
A c C
is pressed, and
u
.
Q