Preparing.the.cash.register; Initializing The Cash Register; Installing Batteries - Sharp XE-A107 Instruction Manual

Preparing.the.Cash.Register

Please do the following before using the register for the first time.
For installing the cash register, find a stable surface near an AC outlet where the cash register will
not subject to water sources or direct sunlight, then install the register.
1. Initializing.the.Cash.Register
For your register to operate properly, you must initialize it before programming for the first time.
Follow this procedure.
1.
Insert the mode key into the mode switch and turn the key to the REG
position.
2.
Plug the AC adapter connector into the AC adapter jack, then plug the AC
adapter plug into the wall outlet.
IMPORTANT:. This operation must be performed without batteries loaded.
Never install the batteries into the register before initializing it. Before you start operating the
register, you must first initialize it, then install three new alkaline batteries LR6 ("AA" size) on
the register. Otherwise, distorted memory contents and malfunction of the register will occur.
3.
The register display should now show "
4.
Press to confirm the clock starts from "
Q
5.
Press to cancel the time display.
l
• This register does not have a sound function. No sound will be made when operations
NOTE
such as pressing keys are performed, however this is normal and is not a malfunction.
• If this does not happen when inserting the AC adapter, then the initialization has not been
done successful. (This will occur when the voltage is high because you operated the
cash register before starting initialization.) Wait at least one minute after pulling out the
AC adapter and reinsert the AC adapter into the AC outlet only after this waiting time has
passed.
2. Installing.Batteries
Batteries must be installed in the cash register to prevent data and programmed contents from
being lost from the memory in case of accidental disconnection of the AC adapter or power failure.
Please install three new alkaline batteries LR6 ("AA" size) before programming and operating the
cash register.
• Before inserting the battery, make sure the AC adapter is connected and the power is on.
NOTE
• Be sure to observe precautions shown on page 1 when handing batteries.
1.
Remove the printer cover.
Caution:. . . T he.paper.cutter.is.mounted.on.the.printer.cover..Be.
careful.not.to.cut.yourself.
6 6
0.00".
0-00".