Honeywell FUSION III DVR User Manual page 73

5 Image Port
6 Search Port
7 Web Function
8 Enable Web Viewer
9 Internet Port
10 Enable Health
Check
11 Quality
12 Resolution
13 Transport Rate
14 View IP Address
15 PPP Setup
(Emergency)
16 Enable Audio
Communication
17 Upgrade Port
18 Use Keyboard
Control
The Image Port is the port used to transfer the video
to the Fusion Remote Software. If connecting through
a firewall, this port must be opened to incoming and
outgoing traffic.
The Search Port is the port used to transfer the
Search information to the Fusion Remote Software. If
connecting through a firewall, this port must be
opened to incoming and outgoing traffic.
Enables the use of the Web DVR interface as well as
defines users who can access it.
This is the Port that is used by the DVR to transmit
images through the Internet.
Allows FVMS to receive information regarding the
health of the DVR.
Sets the port DVR Health information is transmitted
over. This port must match the port set in FVMS.
Adjusts the resolution quality when transferring video
to a remote client.
Adjusts the resolution of the images being sent to
remote clients. By setting the resolution low, the
images will be sent faster, however, the image quality
will be reduced considerably. When set to Original, full
quality video will be sent (720 x 480) however this is
very bandwidth intensive.
Throttles the bandwidth on the DVR. This option is
based on percentages of images sent.
Allows viewing of the IP configuration of the DVR.
Defines the modem and PPP information to dial to a
remote client when an Alarm Monitor Event is
activated.
Allows one way audio communication from a remote
client to the DVR.
Allows communication from a remote client to the
DVR, allowing upgrades through the specified port.
Allows use of an RS232 Keyboard
SETUP OPTIONS
5–29