Plena Voice Alarm System
6.5.2
Monitor
If the Monitor switch is in the ON position, the internal monitoring loudspeaker of the remote
control is switched on. The volume of the monitoring loudspeaker is set with the Monitoring
Speaker volume control on the rear panel of the remote control.
6.5.3
Termination switch
If there are no remote control extensions connected to the remote control, the Termination
switch must be in the ON position.
6.6
Remote control extension
The remote control extensions are configured using an ID selector and a switch (see
Figure 6.9).
3
Figure 6.9 Remote control settings
6.6.1
Remote control extension ID
The ID of the remote control extension is set using a ID selector. The remote control extension
only controls the voice alarm router that has the same ID. Furthermore, each remote control
extension that is connected to the same remote control must have a unique ID (1 to 9).
6.6.2
Termination switch
The last remote control extension in a sequence of looped-through remote control extensions
must always be terminated. Only for these remote control extensions, put the Termination
switch in the ON position.
Bosch Security Systems B.V.
RCP ext. In
Termination
ID
On
Off
6
1
1...9
Installation and Operation manual
RCP ext.
9922 141 1037x (V2.16) | V0.6 | 2011.09
Configuration | en
73