Power - Bosch Plena Voice Alarm System Installation And Operation Manual

54 en | Connection
Contact
EMG
Fault
Call
Table 5.2 Status output contact
The status output contacts are internal relays. By default, NC is connected to COM. When the
Plena Voice Alarm System enters one of the states that are indicated in Table 5.2, the relay
connects NO to COM.
5.1.12

Power

Introduction
The voice alarm controller has the following power connections:
–
–
Mains power
Proceed as follows to connect the voice alarm controller to the mains power:
1.
Figure 5.16 Voltage selector
Selector
115
230
Table 5.3 Voltage selector
NOTICE!
The Voice Alarm Controller is delivered with the voltage selector in the 230 position.
2.
9922 141 1037x (V2.16) | V0.6 | 2011.09
Mains power connection.
Back-up power connection.
Select the local mains voltage using the voltage selector on the rear of the voice alarm
controller.
230V~
115V~
Apparatus delivered
Connected for 230V~
Mains voltage V(AC)
100 - 120
220 - 240
Put the correct type of fuse in the voice alarm controller (see Table 5.3).
Installation and Operation manual
Description
Emergency state (see section 7.4 ).
Fault state (see section 7.5 ).
Call active state.
Power
Plena Voice Alarm System
Fuse
115 V - 10 AT
230 V - 6,3 AT
Bosch Security Systems B.V.