Bosch Plena Voice Alarm System Installation And Operation Manual page 25

Plena Voice Alarm System
5.
6.
7.
8.
9.
10. Alert message button:
11. Alarm message button:
12. Microphone socket:
13. Bracket:
14. Monitoring loudspeaker:
15. Ground:
16. Firmware upgrade connector:
17. Firmware upgrade switch:
18. Remote control extension sockets:
19. Configuration settings:
20. Controller socket:
21. Emergency microphone volume control:
Bosch Security Systems B.V.
Emergency call zone selectors:
Six buttons to select the zones to which the emergency call must be distributed (see
section 7.4 ). Each button has a green and a red LED. The six red LEDs indicate the zones
that are selected for the emergency call. The six green LEDs indicate the zones in which a
business call is running.
BGM zone selectors:
Six buttons to select the zones to which the BGM is distributed (see section 7.2 ). Each
button has a green LED. The six green LEDs indicate the zones to which BGM is
distributed. It is not possible to control the volume of the BGM with the remote control.
All call button:
A button to select all zones. This button is only available in the emergency state (see
section 7.4 ).
Indicator test button:
A button to test all LEDs on the front panel of the remote control and all connected
remote control extensions. All LEDs are lit as long as the button is pushed (see section
7.5 ).
Emergency button:
A push button to put the system in the emergency state (see section 7.4 ).
A button to select the alert message. This button is only available in the emergency state
(see section 7.4 ).
A button to select the default alarm message. This button is only available in the
emergency state (see section 7.4 ).
A socket to connect the hand-held emergency microphone (see section 5.1.1 ).
A bracket for the hand-held emergency microphone that is supplied with the remote
control.
Built-in monitoring loudspeaker.
A connection to electrically ground the remote control.
An RS232 connector to connect a PC to upgrade the firmware of the remote control.
A switch to upgrade the firmware of the remote control.
Two redundant RJ45 sockets to connect remote control extensions to the remote control
(see section 5.4.2 ).
A set of DIP switches to configure the remote control (see section 6.5 ).
One RJ45 socket to connect the remote control to the voice alarm controller (see section
5.4.1 ).
A rotary knob to set the volume of the hand-held emergency microphone.
Installation and Operation manual
System overview | en
9922 141 1037x (V2.16) | V0.6 | 2011.09
25