Bosch Plena Voice Alarm System Installation And Operation Manual page 144

144 en |
Clause / Requirement
13.5.1 A fault in any voice alarm transmission
path between the VACIE and other components
of the voice alarm system shall not affect the
correct functioning of the VACIE or of any other
voice alarm transmission path.
9922 141 1037x (V2.16) | V0.6 | 2011.09
Compliance
The Plena Voice Alarm System has the
following voice alarm transmission paths
between itself and other parts of the
voice alarm system:
–
–
If there is a fault in the transmission path
between the CIE and an input contact of
the Plena Voice Alarm System, the
configured action of the input contact
will not be automatically activated or de-
activated. The correct functioning of the
Plena Voice Alarm System or of any other
voice alarm transmission path is
therefore not affected. The fault will be
reported.
If there is a fault in the transmission path
between the CIE and the Ethernet
connection of the controller of the Plena
Voice Alarm System (connection via
Open Interface), methods can no longer
be invoked by the CIE and no events can
be notified to the CIE. However the fault
will not affect the correct functioning of
the Plena Voice Alarm System or any
other voice alarm transmission path. The
fault will just be reported.
If there is a fault in the transmission path
between the Plena Voice Alarm System,
i.e. the amplifier outputs and the
loudspeaker(s), the loudspeaker(s) will
not be able to produce the intended
audio signal. However the fault will not
affect the correct functioning of the
Plena Voice Alarm System or any other
voice alarm transmission path. The fault
will just be reported.
Installation and Operation manual
Plena Voice Alarm System
transmission path between CIE and
Plena Voice Alarm System via input
contact or Open Interface;
transmission path between Plena
Voice Alarm System and the
loudspeaker(s).
Bosch Security Systems B.V.
Signature