Sending Data To A File Server - Canon image RUNNER 3245 Getting Started Manual

Sending Data to a File Server

The following operations and settings are required to send data to a file server with the machine.
•
For information on the system requirements for using this function, see "Sending Data, " on p. 3-6.
•
If you are using an AppleTalk network, you cannot use this function.
•
The file servers you can use depend on the network you are using. For information on the file servers you can use,
refer to the following, according to the network you are using.
- For a TCP/IP network: see "Setting Up a Computer as a File Server, " on p. 5-30.
- For a NetWare network: see "Setting Up a Computer as a File Server, " on p. 6-7.
- For a NetBIOS netowork: see "Setting Up a Computer as a File Server, " on p. 7-6.
1
Connect the machine to the network.
See "Connecting to a Network, " on p. 4-3.
See "Interface Settings, " on p. 4-9.
2
Set the machine for the type of network you are using.
For a TCP/IP network
See "TCP/IP Network Setup Procedures, " on p. 5-2.
See "Protocol Settings, " on p. 5-3.
For a NetWare network
See "NetWare Network Setup Procedures, " on p. 6-2.
See "Protocol Settings, " on p. 6-3.
For a NetBIOS network
See "NetBIOS Network Setup Procedures, " on p. 7-2.
See "Protocol Settings, " on p. 7-3.
Operations Required to Use the Machine
1
1-7