Table of Contents
Advertisement
PAGE 7
Quick Start Install
Step 1 - Connect All Of the Following Wires
14 Pin Power Connector
Black
Ground Input
Yellow
Ignition Input
Red
Main Power Input
White
(+) Park lights
Brown
(+) Siren Output
Green*
(-) Door Input
Purple*
(+) Door Input
*Test for door pin type (Positive or Negative) then connect the
appropriate wire (Green or Purple)
Step 2- Plug-In The Module
When all the connections are done, the control module can be plugged in.
Before connecting the control module, make sure the ignition is in the OFF
position. Plug in the 13 pin harness then followed by any other connectors that
were used. The system will confirm with two siren chirps and park light flashes.
Step 3 - Test The System
1. Open all the vehicles windows.
2. Press the Lock button to arm the system.
3. Wait five seconds (or until the dome light goes out) then reach in
through a window and open the door. The alarm will then activate
(repeat on all the doors).
4. Test the Shock Sensor again and adjust if necessary.
5. Insure that all additional features are working as intended.
6. If necessary proceed to Program Mode to adjust the programmable
outputs.
Your Basic Install Is Complete!
INSTALL GUIDE
System ground input.
Input from vehicles ignition wire.
Constant power input.
Programmable - menu 2, setting 3.
Positive output for siren.
Negative door pin switch input.
Positive door pin switch input.
Advertisement
Table of Contents
