Ultra Start 640 Series Install Manual page 6

INSTALL GUIDE
2 Pin Connector (Brown wire with female connectors)
Starter Disable harness. See page 4 for installation instructions
14 Pin Connector
Brown (+) Siren Output
Pink Channel 4 Output
Wht/Blue Channel 5 Output
Red Main Power Input
Black Ground Input
Grey (-) Trunk Release
White (+) Park lights
Orange (-) When Armed
Blk/White (-) Dome Light
Purple (+) Door Input
Green (-) Door Input
Blue (-) Hood Input
Yellow Ignition Input
4 Pin Connector Blue
This connector is for the RF antenna. The antenna also contains 2 LEDs and the
Program Button.
4 Pin Connector Red
Green Door Lock
Red 12 Volt Output
Blue Door Unlock
Pink Second Unlock
4 Pin Connector White
Blue Sensor Full Warn
Green Sensor Pre Warn
Black Ground Output
Red 12 Volt Output
* This output is designed to operate one siren. If more than one is being added, a relay
must be installed to avoid damaging the module.
**Channel 4 is activated by holding the Star button on the transmitter.
*** Channel 5 must be programmed to activate on the # button. This channel works on
the horn output, if the 5th channel is programmed the horn output will function as
5th Channel.
****500ma outputs are low current and are designed to activate relays.
*****This is a low current 12volt output designed for use with a voltage inverter.
******This output will activate on the second press of unlock within 3 seconds.
Positive output for siren*
Programmable - See menu 2**
Programmable - See menu 2***
Constant 12 Volt input
System ground input
Negative trunk release. 500ma****
Programmable - 10amp Maximum
Negative output when system is armed****
Dome light supervision****
Positive door pin switch input
Negative door pin switch input
Negative input from hood pin switch
Input from vehicles ignition wire
Programmable - menu 1, setting 3.
Output for voltage inverter only*****
Programmable - menu 1, setting 3.
Programmable - menu 1, setting 3******
Input trigger for addition alarm sensor(s)
Input trigger for addition alarm sensor(s)
Ground output for addition alarm sensor(s)
12 volt output for additional alarm sensor(s)
PAGE 6