Table of Contents
Advertisement
PAGE 9
Programming Overview
Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of
experience. The system's default settings do not require any program changes
in most cases. However, this system does incorporate a highly advanced
programming system that includes 2 menus with numerous options and
settings that can be easily adjusted for custom installations and applications.
Entering Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON-OFF-ON-OFF-ON. Leave Key ON.
3) Press and release the Program Button one time. Park lights will come and
the siren will chirp to confirm entering Program Mode.
4) Select Desired Program Menu by the following:
Press Button #1
Press Button #2
5) The selected mode will be confirmed by a siren chirp and park light flash.
6) The Program Menu may be changed at any time by pressing the transmitter
buttons as above, this allows the installer to change a setting from one
menu, then quickly jump to another menu and change another setting
without exiting Program Mode.
7) Program Mode will be exited if there is no activity for 30 second or if the key
is turned to the "Off" position. This will be confirmed by one siren chirp and
park light flash.
NOTE:
If unit does not enter Program Mode, turn ignition off and repeat steps 1-4.
** The ignition wire(Yellow) MUST be connected to the vehicle's ignition wire.
If it is not connected it will not be possible to enter the Program Modes.
Changing the Programmable Settings
1) Enter Program Mode.
2) Select the desired Program Menu. (See pages 10-12)
3) Press & release the Program Button the correct number of times to select
the desired Program Setting(as listed on pages (10-12). The park lights will
flash and the siren will chirp to indicate the current setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the
selected setting. The park lights will flash and the siren will chirp to indicate
the option selected within the setting.
5) Turn the ignition key "Off" to exit Program Mode.
Lock
Unlock
INSTALL GUIDE
User Options Page 10.
Alarm Settings Page 11-12.
Advertisement
Table of Contents
