Plug-In The Module - Ultra Start 45 SERIES Install Manual

REMOTE VEHICLE STARTER
Step 1 - Connect All Of the Following Wires
6 Pin Power Connector
Yellow 30amp Starter Output
Green 30amp Heater Output
Red 30amp Power Input
Red 30amp Power Input
Blue 30amp Ignition Output
White* 30amp Select Output
*Note: The white wire may not be required on all vehicles.
14 Pin Connector
Black System Ground Input Connect to Chassis Ground.
White Park Light Output
Green/Wht Hood Pin Input
Blue/Wht Tach
Pink Brake Switch
Wht/Blue Siren
Green* (-) Door Pin Input
Purple* (+) Door Pin Input
* Connect only one of the door pin inputs. If the vehicle has a positive door pin
system connect the purple wire, if negative connect the green wire.
Manual Transmission Connections ("M" Models Only)
Black/Wht Park Brake Input
Never install an automatic module into a manual transmission vehicle!
Step 2- Plug-In The Module
When all the connections are done, the control module can be plugged in. Before
connecting the control module, make sure the ignition is in the OFF position. Plug
in the 6 pin harness and the Auxiliary harness, then any other connectors that were
used. The park lights will flash and the siren will chirp 2 times to confirm power
up on automatic transmission models. Manual transmission models will flash the
park lights and chirp the siren 4 times to confirm power up.
INSTALLATION MANUAL
12volts during start position only.
12volts in the accessory position off during
start and 12volts during run.
Constant 12volt power at ignition harness
or from battery.
Constant 12volt power at ignition harness
or from battery.
12volts in the ignition, start and when run
positions.
Selectable Output for vehicles that require
2nd Ign, Acc or Starter wires.
Connect to (+) Park Light system.
Connect to the Hood Pin Safety Switch.
Connect To A/C Tach Source.
Connect To (+) When Brakes Is Applied.
Connect to Siren Positive Activation.
Connect to door pin (-) when doors opened
Connect to door pin (+) when doors opened
Connect to Park Brake wire.
Page 9