Ultra Start 640 Series Install Manual page 11

Advanced remote vehicle security systems
Hide thumbs Also See for 640 Series:
Table of Contents

Advertisement

PAGE 11
Menu 2- Alarm Settings
Setting 1 - Car Finder/ 5th Channel
1 Car Finder OFF
*2 Car Finder ON
Press the Program Switch 1 time to select setting 1 (This will be confirmed by 1 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes and/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
NOTE: To operate the 5th channel on the
buttons, Menu 2, Setting 7 must be programmed for 5th channel output.
Setting 2 - Secure Program Mode
1 Secure Program Active
2* Normal Program Active
Press the Program Switch 2 times to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
Setting 3 - Park Light Output
1 Parking Lights on Disarm
2 Negative Park Light
3* Normal Parking Lights
Press the Program Switch 3 times to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
Setting 4 - Horn Honk Timing
1 5ms Pulsed Output
2 20ms Pulsed Output
*3 10ms Pulsed Output
Press the Program Switch 4 times to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
1 Light Flash
2 Light Flashes
1 Flash
2 Flashes
1 Flash
2 Flashes
3 Flashes
1 Flash
2 Flashes
3 Flashes
INSTALL GUIDE
Car Finder Mode Disabled
Car Finder Mode activated when
(640/660 only) and the
Ignition "ON" and Program switch held for 15 seconds
Ignition "ON" and Program switch held for 5 seconds
Park Lights on for 30 seconds on disarm
Switches Park Light and the Trunk Release outputs
2 Park Light Flashes on disarm
Short (Quiet) Pulses
Long (Loud) Pulses
Normal (Medium) Pulses
button is held.
(606)

Advertisement

Table of Contents
loading

This manual is also suitable for:

660 series670 series606 series

Table of Contents