Table of Contents
Advertisement
INSTALL GUIDE
Menu 2- Alarm Settings
Setting 5 - 4th Channel Settings
1 Pulsed Output
2 Latched Output
*3 Active Output
Press the Program Switch 5 times to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
NOTE: The shock sensor and ignition inputs are bypassed upon activation.
Setting 6 - Car Jack Mode
1 Type 1
2 Type 2
*3 Car Jack OFF
Press the Program Switch 6 times to select setting 6 (This will be confirmed by 6 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
Setting 7 - Horn/ 5th Channel
1 5th Channel
2 LED Output
*3 Horn Honk
Press the Program Switch 7 times to select setting 7 (This will be confirmed by 7 LED flashes)
Press and hold the Program Switch until you receive the appropriate # of park light flashes &/or siren chirps.
Release the Program Switch. To move to next program step or repeat to change selection.
NOTE: 5th Channel not available with 670
continued...
1 Flash
Pulsed for 0.75 seconds upon 4th Channel Activation
2 Flashes
3 Flashes
1 Flash
Press button #4 or open the door while the Ignition is "ON"
2 Flashes
Press button #4 or by turning the Ignition "On"
3 Flashes
No Car Jack Functions
1 Flash
2 Flashes
3 Flashes
(
(640/660/670)
Latched until repeated or ignition "ON"
Active for as long as the button is held on Transmitter.
(
(640/660 only)
Active for as long as the
Pulsed output for addition LED activation
Horn Honk with Arm & Disarm Chirps
PAGE 12
)
(606)
(606)
button is held.
)
Advertisement
Table of Contents
