GE JGSP32 Use And Care Manual page 36

PROBLEM
AND A NUMBER"
"F-
FLASH
IN THE DISPLAY
BURNERS HAVE YELLOW OR
YELLOW-TIPPED FLAMES
SURFACE BURNER KNOBS
WILL NOT TURN
SURFACE BURNERS
DO NOT LIGHT
TICKING SOUND
OF SPARK IGNITER
PERSISTS A~ER
BURNER LIGHTS
TICKING SOUND
PERSISTS A~R
BURNER 1S
TURNED OFF
BURNER FLAMES VERY
LARGE OR YELLOW
FOOD DOES NOT
BROIL PROPERLY
36
QUESTIONS?
USE THM PROBLEM SOLmR
POSSIBLE CAUSE
a function error code. Press the CLEAWOFF
disconnect all power to the range. Call for service.
for service
Call
If burner
flames look like (A), call for service. Normal burner flames should
look like (B) or (C), depending on the type of gas you use.
from OFF positi(m, push the knob in and then turn.
Gas supply not connected or not turned on.
Check
for power outage.
for combustion. Remove pan and try again.
Igniter {)rifice in burner kdy may be clt~gged. See the Care and
Cleaning section. Remove the obstruction.
Burner parts not replaced correctly. See the Care and Cleaning sectit)n.
Hole in burner top behind igniter may be clogged. Usc a small sewing
needle to unplug.
Turn knob out of the LITE posit(m.
burner off and relight. [f ticking is still present, call for service.
Be sure knob is in the OFF position. Remove knob by pulling it straight off
the stem and check bottom" of knob for any build-up of soil.
If range is connected to LP gas. check all steps in the Installati(m Instructit)ns.
. The oven controls are nf)t properly set. See the Broiling section.
The dmr is not closed.
Improper shelf position is being used. See the Broiling section.
Food is being cooked on a hot pan.
Cookware is not suited for broiling.
as ~ommended.
Put the t)ven hack int(] t)peration. If the failure code repeats,
for LP gas
tipping on outer cones is normal.
(C) Sofi
blue flmn-
for natural gas
Normal