Additional Information; Troubleshooting; Additional Information Troubleshooting - Pioneer DVH-P5000UB Operation Manual

Additional Information

Troubleshooting

Common
Symptom
Power doesn't turn on.
The unit doesn't operate.
Operation with the remote con-
trol isn't possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
Playback is not possible.
No sounds are heard.
The volume level will not rise.
The icon is displayed, and op-
eration is not possible.
The picture stops (pauses) and
the unit cannot be operated.
There is no sound.
Volume level is low.
There is audio and video skip-
ping.
The picture is stretched, the as-
pect is incorrect.
When the ignition switch is
turned ON (or turned to ACC),
the motor sounds.
Cause
Leads and connectors are incor-
rectly connected.
The fuse is blown.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
The remote control operation mode
is incorrect.
Battery power is low.
Some operations are prohibited
with certain discs.
The disc is dirty.
The loaded disc is a type this unit
cannot play.
Non compatible video system disc
is loaded.
Cables are not connected correctly.
The unit is performing still, slow mo-
tion or frame-by-frame playback.
The operation is prohibited for the
disc.
The operation is not compatible
with the disc's organization.
Reading of data has become impos-
sible during playback.
The volume level is low.
The attenuator is on.
The unit is not firmly secured.
The aspect setting is incorrect for
the display.
The unit is confirming whether a
disc is loaded or not.
Action (See)
Confirm once more that all connections are
correct.
Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install a fuse
with the same rating.
Turn the unit off and then on.
Switch to the correct remote control mode.
(Page 16)
Load new battery. (Page 12)
Check by using another disc.
Clean disc. (Page 84)
Check what type the disc is.
Change to a disc compatible to your video
system.
Connect the cables correctly.
There is no sound during still, slow motion or
frame-by-frame playback.
This operation is not possible.
This operation is not possible.
After stopping playback once, start playback
once more.
Adjust the volume level.
Turn the attenuator off.
Secure the unit firmly.
Select the appropriate setting for your display.
(Page 49)
This is a normal operation.
Appendix
79
En