Adjusting The Speaker Output Levels Using A Test Tone; Using The Time Alignment - Pioneer DVH-P5000UB Operation Manual

Section
03 Available accessories
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Use MULTI-CONTROL to select
TEST TONE.
Refer to Introduction of DSP adjustments on
page 67.
2 Push MULTI-CONTROL right to start the
test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-LEFT (front speaker left)—CENTER
(center speaker)—FRONT-RIGHT (front speak-
er right)—REAR-RIGHT (rear speaker right)—
REAR-LEFT (rear speaker left)—SUB WOOFER
(subwoofer)
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
# The settings do not appear for speakers
whose size is set OFF. (Refer to Setting the speak-
er setting on page 73.)
3 Push MULTI-CONTROL up or down to
adjust the speaker output level.
+10 to –10 is displayed as the level is in-
creased or decreased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Push MULTI-CONTROL left to stop the
test tone output.
5 Press BAND to return to the ordinary
display.
76
En
Notes
! If needed, select speakers and adjust their 'ab-
solute' output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at FRONT-LEFT. Both provide the
same results.

Using the time alignment

The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Use MULTI-CONTROL to select TA.
Refer to Introduction of DSP adjustments on
page 67.
2 Push MULTI-CONTROL left or right to
select the time alignment.
! INITIAL – Initial time alignment (factory set-
ting)
! CUSTOM – Adjusted time alignment that
you can create for yourself
! AUTO TA – Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on
page 71.)
! OFF – Turn the time alignment off
# If auto TA and EQ have not been carried out,
SET AUTO TA is displayed when AUTO TA is se-
lected.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in CUSTOM.
1 Use MULTI-CONTROL to select FRONT-L.
Refer to Introduction of DSP adjustments on
page 67.