Using Balance Adjustment; Using The Position Selector; Using The Dolby Pro Logic Ii - Pioneer DVH-P5000UB Operation Manual

Section
03 Available accessories
# You cannot select AUTO EQ if auto TA and EQ
has not been carried out.
# To return to the display of each source, press
BAND.
# If you do not operate the DSP function except
for TEST TONE, FRONT-L and PEQ-2 within about
30 seconds, the display is automatically returned
to the source display.

Using balance adjustment

You can change the fader/balance setting so
that it can provide the ideal listening environ-
ment in all occupied seats.
1 Use MULTI-CONTROL to select FADER.
Refer to Introduction of DSP adjustments on
the previous page.
# If the balance setting has been previously ad-
justed, BALANCE will be displayed.
2 Push MULTI-CONTROL up or down to
adjust front/rear speaker balance.
FADER :F25 to FADER :R25 is displayed as the
front/rear speaker balance moves from front to
rear.
# FADER :F/R0 is the proper setting when only
two speakers are used.
3 Push MULTI-CONTROL left or right to
adjust left/right speaker balance.
BALANCE :L25 to BALANCE :R25 is displayed
as the left/right speaker balance moves from
left to right.

Using the position selector

One way to assure a more natural sound is to
accurately position the stereo image, putting
you right in the center of the sound field. The
position selector function lets you automati-
cally adjust the speaker output levels and in-
serts a delay time to match the number and
position of occupied seats. When used in con-
68
En
junction with the SFC, the feature will make
the sound image more natural and offer a pa-
noramic sound that envelops you.
! When you make adjustments to the listen-
ing position, the speaker outputs are auto-
matically set for appropriate levels. You can
tailor the levels more precisely referring to
Adjusting the speaker output levels using a
test tone or Adjusting the speaker output le-
vels.
1 Use MULTI-CONTROL to select
POSITION.
Refer to Introduction of DSP adjustments on
the previous page.
2 Push MULTI-CONTROL left, right, up or
down to select a listening position.
Direction Display Position
FRONT-L
Left Front seat left
Right FRONT-R Front seat right
FRONT
Up Front seats
Down ALL All seats
# To cancel the selected listening position, push
MULTI-CONTROL in the same direction again.

Using the Dolby Pro Logic II

Dolby Pro Logic II creates five full-bandwidth
output channels from two-channel sources to
achieve high-purity matrix surround.
! If both the center and the rear speakers are
set to OFF, you cannot use this function.
! Dolby Pro Logic II supports up to 48kHz
sampling rate stereo source and has no ef-
fect on other types of source.
1 Use MULTI-CONTROL to select PLII.
Refer to Introduction of DSP adjustments on
the previous page.