Pioneer DVH-P5000UB Operation Manual page 44

Section
02 Operating this unit
! CUSTOM is an adjusted equalizer curve
that you create. If you make adjustments to
an equalizer curve, the equalizer curve set-
ting is memorized in CUSTOM.
! When FLAT is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
FLAT and a set equalizer curve.
% Press EQ to select the equalizer.
Press EQ repeatedly to switch between the fol-
lowing equalizers:
POWERFUL—NATURAL—VOCAL—CUSTOM
—FLAT—SUPER BASS
Note
You can also perform this operation in the audio
menu that appears by using MULTI-CONTROL.
Adjusting equalizer curves
The factory supplied equalizer curves can be
adjusted to a fine degree (nuance control).
1 Use MULTI-CONTROL to select EQ-LOW.
Equalizer band (e.g., EQ-LOW : 0) appears in
the display.
Refer to Introduction of audio adjustments on
the previous page.
# If the equalizer band has been previously se-
lected, the band of that previously selected will be
displayed instead of EQ-LOW.
2 Push MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time MULTI-CONTROL is pushed left or
right, equalizer bands are selected in the fol-
lowing order:
EQ-LOW (low)—EQ-MID (mid)—EQ-HI (high)
44
En
3 Push MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time MULTI-CONTROL is pushed up or
down, the level of the equalization band in-
creases or decreases.
+6 to –6 is displayed as the level is increased
or decreased.
# You can then select another band and adjust
the level.
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (EQ-LOW/EQ-MID/
EQ-HI).
! If you make adjustments, CUSTOM curve
is updated.
Level (dB)
Center frequency
1 Use MULTI-CONTROL to select the
equalizer band to adjust.
Refer to Adjusting equalizer curves on this
page.
2 Use MULTI-CONTROL to select EQ-LOW.
Frequency and the Q factor (e.g.,
EQ-LOW 80HZ Q1W) appears in the display.
Refer to Introduction of audio adjustments on
the previous page.
3 Push MULTI-CONTROL left or right to
select the desired frequency.
Each time MULTI-CONTROL is pushed left or
right, frequencies are selected in the following
order:
Q=2W
Q=2N
Frequency (Hz)