WHEELS, TIRES
Installing the rear wheel
12.4
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
x
Main work
–
Check the rear hub rubber dampers.
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
–
Clean and grease the shaft seal rings
Long-life grease (
–
Clean the thread of the axle and nut
–
Clean the fixing locations on the brake caliper support and swingarm.
–
Install the rubber damper and rear sprocket carrier on the rear wheel.
B00748-10
–
Stand the rear wheel in the swingarm and mount the brake caliper on the brake disc.
–
Position the rear wheel on the contact surfaces in the swingarm.
–
Push the rear wheel as far forward as possible and place the chain on the rear sprocket.
Change the wheel bearing.
x
p. 162)
x
(
p. 97)
and mating surfaces
of the spacers.
1
A
.
2
96