Transmitters - Genie M-4500 Owner's Manual

10. TRANSMITTERS

INSTALLING THE BATTERY (Fig. 47.):
I Remove battery compartment cover (back of transmitter)
by using small screwdriver.
I Insert the provided 12V battery (type 23A) as shown.
I Replace battery compartment cover.
NOTE: Replace batteries with same type only.
TRANSMITTER MOUNTING:
The transmitters can be conveniently mounted inside your
car using the mounting plate, or visor clip.
A. Mounting Plate (Fig. 48)
I Secure the mounting plate to area of preference using
velcro (not provided) or other means.
I Snap the transmitter into the mounting plate, which will
hold it firmly in place.
B. Visor Clip (Fig. 48)
The visor clip permits easy mounting of transmitter to a visor.
I Attach visor clip to mounting plate.
I Snap transmitter into mounting plate.
I Affix complete assembly to visor.
MULTIPLE TRANSMITTERS:
Each transmitter comes factory programmed with random
codes. 1-channel transmitters have one random code, and
2-channel transmitters have 2 different random codes, one
per button. Transmitters that are purchased separately as
accessories have random codes that must be changed in
order to match the code of the "active" transmitter you are
already using. Below are instructions for transferring an
active code.
I Remove battery compartment covers of both transmitters,
the one with the active code and the new transmitter that
needs to receive the active code. See Fig. 47.
I Connect the programming cable to both transmitters.
Line up either end of stripped cable so 3 wires align with
3-hole terminal, then firmly insert cable. See Fig. 49.
I Press and hold button on transmitter with the active code
((L) in Fig. 49). Midi transmitters have indicator lights that
will blink to show that code transfer is ready.
I While keeping the transmitter (L) button pressed, press
and hold the button on the new transmitter (R) that you
want to transfer the active code to.
I Code transfer will occur in approximately 2 seconds. The
indicator light will illuminate continuously to show that
transfer is complete.
I All buttons can be released. Cable can be removed and
the covers replaced.
I Both transmitters can now be used to operate the same door.
NOTE: For multi-button transmitters, be sure to carry out
this procedure for all the buttons you desire to use.
CODE CHANGE:
The transmitter factory preset code can be changed as follows:
I Remove battery cover from compartment.
I Connect the programming 3-prong cable to programming
terminal in transmitter. (Fig. 50).
I Cross any two wires of programming cable, one of them must
be the center wire.
I Press and hold button on the transmitter.
I Code will change in approximately 2 seconds.
I Release button after the light illuminates continuously, then-
remove the cable and replace the cover.
22
Fig. 47
Programming
Cable
3-Hole
Terminal
Fig. 48
Midi 2-Channel
L
Fig. 49
Transmitter
with Active
Code
L
R
Light Light
Blinks Off
Press First
Press Second
and hold and hold
FCC Certified: This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Fig. 50
NOTE: For multi-button transmitters, be sure to carry out
this procedure for all the buttons you desire to use.
Battery
Compartment
Cover
12 V
(type 23A)
Battery
Fully Assembled
Transmitter
Mounting Plate
Visor Clip
R
New
Transmitter
L
R
Light Light
Blinks Illunimates
Continuously
Keep Pressed
Release when
Light Illunimates
Continuously