Angle Adjustment - Invacare Solara 3G User Manual
Hide thumbs
Also See for Solara 3G:
- Service manual (160 pages) ,
- User manual (136 pages) ,
- Quick manual (8 pages)
Table of Contents
Advertisement
Front Riggings
3.
Retighten the two flat screws and locknuts.
The setting for positioning the footplate on the half clamp may vary for each footplate.
4.
Repeat STEPS 1-3 for opposite footplate, if desired.
Angle Adjustment
1.
Loosen, but DO NOT remove the adjustment screw in the half clamp.
2.
Position the footplate to the necessary angle to accommodate the user (Detail "A").
3.
Retighten the adjustment screw. Torque to over 90 in-lbs, but no more than 300 in-lbs.
4.
Repeat STEPS 1-3 for opposite footplate, if desired.
5.
Screw in or out until the adjustable angle flip-up footplate is perpendicular to the footrest assembly or the desired inversion/eversion is obtained.
Footrest Support
Footplate
Detail "A" - Side
View of Footplate and
Footrest Support
Solara 3G/Spree 3G Wheelchair
FIGURE 5 Adjusting Adjustable Angle Flip-Up Footplates
40
90° Footrest Support
Flat Screws
Footplate
Half Clamp
Adjustment Screw
Footplate
Hinge
Locknuts
Part No 1154295
Advertisement
Table of Contents
Troubleshooting
