Invacare Solara 3G User Manual page 77

2. Repeat STEP 1 for opposite side of wheelchair.
 To determine tilt angle relative to the seat frame, place a magnetic protractor (available at any hardware store) on the back
and adjust the back until the magnetic protractor reads desired angle of tilt.
3. Tilt the wheelchair to the desired angle of tilt.

The Solara seat frame is at a 5° back angle relative to the ground.
4. Position the two tilt locking collars against the bearing housing.

Before tightening, ensure that the two tilt locking collars are at the same position on the tilt slide.
5. Securely tighten the two set screws of the tilt locking collars.
Part No 1154295
Bearing Housing
Upper Tilt
Locking Collar
Set Screw
Tilt Slide
FIGURE 4 Adjusting Upper Tilt Locking Collar.
77
12 TILT
Solara 3G/Spree 3G Wheelchair