Installing Adjustable Angle Flip-Up Footplate Hinge - Invacare Solara 3G User Manual

Front Riggings
FIGURE 3 Installing/Removing Footrests - 70° MFX, 90°, 70° LIFT and 90° LIFT Footrests.
9.3

Installing Adjustable Angle Flip-Up Footplate Hinge

1. Position the adjustable angle flip-up footplate hinge on the footrest support tube at the desired height.
2. Position the hardware on the footrest support as shown in FIGURE 3.
3. Flip the footplate hinge to the up position.
4. The footplate hinge will fall to the down position.
5. Tighten the socket screw and locknut that secure the footplate hinge to the footrest support until the footplate hinge remains in the up position.
6. Check the up and down motion of the footplate hinge to make sure the user of the wheelchair can operate the footplates easily.
7. If the footplate's motion is:
• too tight, loosen the socket screw and locknut approximately
• too loose, tighten the socket screw and locknut approximately
Solara 3G/Spree 3G Wheelchair
Locknut
Footplate
1
/ turn.
4
1
/ turn.
4
38
Footrest Support
Height
Adjustment Holes
Socket Bolt
Part No 1154295