Installing/Adjusting Anti-Tippers - Invacare Solara 3G User Manual

Wheel Locks/Anti-Tippers

15.4 Installing/Adjusting Anti-Tippers


1
A /
1 to 2
2
Installing the Anti-Tippers
1. Remove the anti-tippers from the accessory carton.
WARNING
Anti-tippers MUST be fully engaged and spring buttons fully protruding out of adjustment holes
2. Press the release buttons in and install the anti-tippers with the wheels facing down until the locking buttons lock in place (FIGURE 8).
3. Adjust the anti-tippers. Refer to Adjusting the Anti-Tippers on page 94.
Adjusting the Anti-Tippers
1. Depress the release button on the wheeled portion of the anti-
tipper and slide it up/down to achieve 1
WARNING
Anti-tippers MUST be fully engaged and release
buttons fully protruding out of same respective
adjustment holes BEFORE use. This will avoid a 3-
Wheeling situation..
2. Ensure that the release buttons are fully engaged in the adjustment
1 1
holes and 1 / to 2 /
2 4
1 1
3. If a 1 / to 2 / inch clearance cannot be obtained, contact a
2 4
qualified technician.
4. Repeat STEPS 1-3 for opposite side.
Solara 3G/Spree 3G Wheelchair
1
/ between the bottom of the anti-tipper wheels and the floor MUST be maintained at all times.
inch clearance
4
1 1
/ to 2 / inch clearance.
2 4
inch clearance is maintained.
Release Button
Anti-tipper
Release
Button
Anti-tipper (Wheeled
Portion)
FIGURE 8
94
Locking
Button
Wheelchair
Frame
Installing/Adjusting Anti-Tippers
Part No 1154295