Installing Crutch And Cane Carrier; Installing The Seat Positioning Strap - Invacare TRACER EX2 Owner's Operator And Maintenance Manual

Tracer ex2
Hide thumbs Also See for TRACER EX2:
Table of Contents

Advertisement

Installing Crutch and Cane Carrier

Check base weekly to ensure proper placement.
When loading the crutch/cane carrier, ensure items are securely placed into the base. Also
ensure that there is no interference with folding the wheelchair, the rear wheels, or the
swing-back arms.
Strap MUST be securely fastened while carrying items.
NEVER insert or remove items while wheelchair is moving.
NOTE: For this procedure, refer to FIGURE 11.2.
1.
Slide the clamp with the base attached over the end of the step tube of the wheelchair. Ensure the base is towards the 
inside of the wheelchair.
2.
Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to avoid
bending spokes when folding the wheelchair.
3.
Securely tighten the locknut that secures the base to the 
step tube of the wheelchair.
4.
Remove the upper back upholstery screw and washer.
5.
Align the strap with the back upholstery screw 
mounting hole.
6.
Reinstall the back upholstery screw and washer and 
secure the strap to the wheelchair.
7.
The base cleans easily with any chrome or glass cleaner. 
The strap can be cleaned with mild soap and water.

Installing the Seat Positioning Strap

ALWAYS wear your positioning strap. Inasmuch as the seat positioning strap is an option on this wheel-
chair (You may order with or without the seat restraint), Invacare strongly recommends ordering the seat
positioning strap as an additional safeguard for the wheelchair user.
NOTE: For this procedure, refer to FIGURE 11.3.
1.
Remove the bottom back upholstery screw from the
2.
wheelchair.
3.
Position the seat positioning strap half between the 
back cane and back upholstery.
4.
Secure the back upholstery and seat positioning strap to 
the wheelchair with the existing back upholstery screw.
5.
Repeat STEPS 1‐3 for the opposite side of the 
wheelchair.
Part No. 1110546
WARNING
Step
Tube
Locknut
FIGURE 11.2 Installing Crutch and Cane Carrier
WARNING
Back
Upholstery
Strap
Positioning
Strap
FIGURE 11.3 Installing the Seat Positioning Strap
39
SECTION 11—OPTIONS
Strap
Base
Clamp
Back Cane
Back
Upholstery
Tracer® EX2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents