Paper Handling - Epson Stylus COLOR 600 User Manual

The New Hardware Found screen appears even though the
printer software has already been installed.
Cause
This error may occur when
using Windows 95.

Paper handling

Paper does not feed properly from the sheet feeder.
Cause
Too many sheets are loaded
in the sheet feeder.
The edge guides are not set
correctly.
Paper is jammed in the paper
path.
The paper stack does not fit
under the edge guide tab
inside the left edge guide.
The paper is curled or folded. Use flat, undamaged paper.
8-14
Troubleshooting
What to do
Click the Do not install a driver
(Windows will not prompt you
again) button; then click OK.
What to do
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Before you load paper, check the
amount of paper you can load in the
sheet feeder. See Chapter 6.
Adjust the guides against the stack of
paper. See "Loading Paper" in
Chapter 3.
Take all the paper out of the sheet
feeder, reload the paper, then press the
-
load/eject button. If the
light continues to flash, turn off the
printer and gently pull out any paper
that may be jammed in the printer. If it
tears and pieces remain inside the
printer, open the printer cover; then
remove the pieces of paper.
Reload the paper so that it fits under
the edge guide tab. See "Loading
Paper" in Chapter 3.
5
paper out