7. Push the module down so it lies flat. Latches on either side will click into
place to secure the module.
8. Seat the cover and secure it with two screws.
9. Replace the battery pack as described in Chapter 6, Power and Power-Up
Modes.
10. Turn the power on and make sure the added memory is recognized.
Removing memory modules
CAUTION: If you use the computer for a long time, the memory modules
will become hot. In this case, let the memory modules cool to room
temperature before you replace them.
To remove the memory module, make sure the computer is in boot mode then:
1. Be sure the power is off and all cables are disconnected from the computer.
CAUTION: Do not try to remove a memory module with the computer
turned on. You can damage the computer and the module.
2. Turn the computer upside down and remove the battery and two screws
securing the memory module socket cover.
3. Slide your fingernail or a thin object under the cover and lift it off.
4. Push the latches to the outside to release the module. A spring will force one
end of the module up.
Slot B
Figure 7-6 Installing a module
Memory expansion
Slot A
7-11