Lan; Connecting The Lan Cable - Toshiba Satellite P10 series User Manual

NOTE: If modem speed is low or communication is interrupted when you
are using the modem, please check and set the CPU speed to Maximum
within the TOSHIBA Power Management Utility.
Disconnecting
To disconnect the internal modem cable, follow the steps below.
1. Pinch the lever on the connector in the telephone jack and pull out the
connector.
2. Disconnect the cable from the computer in the same manner.

LAN

The computer is equipped with LAN circuits that support Ethernet LAN (10
megabits per second, 10BASE-T) and Fast Ethernet LAN (100 megabits per
second, 100BASE-TX). This section describes how to connect/disconnect to a
LAN.
CAUTION: Do not install or remove an optional memory module while
Wake-up on LAN is enabled.
NOTE: Wake-up on LAN does not work without the AC adaptor. Leave it
connected, if you are using this feature.

Connecting the LAN cable

CAUTION: The computer must be configured properly before connecting
to a LAN. Logging onto a LAN using the computer's default settings could
cause a malfunction in LAN operation. Check with your LAN
administrator regarding set-up procedures.
If you are using Fast Ethernet LAN (100 megabits per second, 100BASE-TX), be
sure to connect with a CAT5 cable. You cannot use a CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you can
connect with either a CAT5 or a CAT3.
To connect the LAN cable, follow the steps below.
1. Turn off the power to the computer and to all external devices connected to
the computer.
LAN
4-22